39
12.Gear removal(when required)
To remove the gears from the camshaft and
fuel injection pump camshaft, use an arbor
press.
13.Oil pump removal
Remove the bolts that hold the oil pump to the
cylinder block and remove the pump.
Do not cause the damage to the lobes or
bearing journals when removing the camshaft.
11.Fuel injection pump camshaft removal
(1)Remove the stopper bolt.
(2)Tap the rear end of the camshaft with a
copper bar to push it out of the front side
of the cylinder block.
14.Front plate removal
Remove four bolts that hold the front plate in
position. Tap the plate lightly with a plastic
hammer to separate the gasket.
To Next Page
Loading...
