144
4) Pull out spool(17)and sleeve(16)from
housing.
(Pull them out to opposite side of flange.)
5) Remove pin (20) from spool (17) and sleeve
(16) assy.
Do not disassemble or adjust the adjust plug
for relief pressure setting at dealer.
9-3 HYDRAULIC CYLINDER DISASSEMBLING
(1) HYDRAULIC CYLINDER ASSY REMOVAL
1. Remove hydraulic hoses (2 hoses) from
hydraulic cylinder.
2. Drain coolant from radiator and remove
radiator drain hose.
6) Push spool in the sleeve slightly as
shown and remove centering springs (19)
(6 pieces) from spool.
Remove spool (17) from sleeve (16) by
pulling to opposite direction of centering
spring (19) removal.
To Next Page
Loading...
