118
3. PTO hydraulic clutch reassembling
For the installation of return plate, face the
stamping surface (round edge side)of the
plate to brake disk.
6-5. CENTER CASE REASSEMBLING
*Reassemble the center case with reverse
procedure of removal.
(1) COVER C SUB ASSY REINSTALLATION
*Reinstall the cover C sub assy with
reverse procedure of removal.
Use following values as adjustment and
service standard for reassembling.
1. Apply liquid packing (three bond #1208D) at
the mating surface of center case and lever
holder.
2. Tightening torque of fixing bolts of lever holder.
[28.93~32.55lbf•ft]
3. Install the stopper to set [0.079~0.118in.]
clearance between stopper and adaptor and
make sure the lever could be move smoothly
in the guide.
(3) 4WD SHAFT REASSEMBLING
*Reassemble 4WD shaft with reverse
procedure of disassembling.
To Next Page
Loading...
