57
10.Oil pan installation
(1)Clean the mating surfaces of the oil pan and
cylinder block and coat them with Three Bond
1207C.
Squeeze out a 4mm(0.2 in.) thick bar of
sealing compound(three Bond) from the
tube and put it on the flange of the oil pan
as shown.
(2)Tighten the bolts that hold the oil pan to
the cylinder block in a crisscross pattern
to the specified torque.
Tightening torque
Cast oil pan:
2.8 0.3 kgf•m
(20.3 2.2 lbf•ft)
[27.5 3 N•m]
Plate oil pan:
1.15 0.15 kgf•m
(8.3 1.1 lbf•ft)
[11.3 1.5 N•m]
To Next Page
Loading...
