Installation
336 PRS-7367
shock, impact and collision, to ensure product packaging integrity.
Check that the consignment is complete immediately upon receipt. Notify the nearest CYG SUNRI
CO., LTD. Company or agent, should departures from the delivery note, the shipping papers or the
order be found.
Visually inspect all the material when unpacking it. When there is evidence of transport damage,
lodge a claim immediately in writing with the last carrier and notify the nearest CYG SUNRI CO.,
LTD. Company or agent.
Unpacking and checking procedures
1. Remove the shipping package.
2. Before unpacking, you should first check the equipment packaging intact, whether there are
signs of serious collision and phenomenon’s that equipment in the box may be damaged. If
found abnormal, it is recommended to take pictures as a record, confirm and contact with the
manufacturer at first time.
3. When unpacking, you should use a claw, and pull out the nails, and then pry off the box lid; If
the crowbar is used, never take the device as a fulcrum, and it is forbidden to stick into the
wooden box carelessly with the crowbar. Open the box with the greatest care and avoid
excessive vibration.
4. Check the appearance of the device is intact.
5. Check the delivery list. Check the device certificate of competency, supporting documents,
attachments, spare parts, etc. are consistent with the order requirements, whether the packing
list and the type, name, quantity, etc. are consistent and complete. If correct, sign the
confirmation.
6. Manufacturer documents and spare parts should be assigned to personal keeping and
registration.
7. If any abnormalities occur during unpacking, feedback CYG SUNRI CO., LTD. Company or
agent at the first time, so as to avoid the follow-up of unclear responsibilities.
If the equipment is not going to be installed and commissioned immediately, store all the parts in
their original packing in a clean dry place and keep air circulation. And to prevent the intrusion of
various harmful gases, non-corrosive items stored in the same place.
11.4 Material and Tools Required
The necessary mounting kits will be provided, including screws, pincers and assembly
instructions.
A suitable drill and spanners are required to secure the cubicles to the floor using the plugs
provided (if this relay is mounted in cubicles).
To Next Page