Installation
PRS-7367 341
11.8.2 Confirm the hardware and software version
Hardware and software version information is available on the device label. After the device is
powered on, the software version can also be checked through the LCD interface.
11.8.3 Device start
if confirm that the wiring is correct during the installation check, you can supply device with power
and start it.
Configuration file needs to read during device startup process. It needs a certain period of time for
the startup process. The startup time is related to the size of configuration file. In general, the
startup time is less than 1 minute.
The "HEALTHY" indicator lights up when the unit starts up normally. If a fault is detected during the
startup procedure, the "ALARM" indicator is lit and the internal fault code, alarm information can be
checked via LEDs.
To Next Page
Loading...