Decommissioning and Disposal
PRS-7367 345
13 Decommissioning and Disposal
13.1 Decommissioning
13.1.1 Switching off
To switch off this relay, break down the cable connected to the power supply module or switch off
the external miniature circuit breaker.
13.1.2 Disconnecting cables
Disconnect the cables in accordance with the rules and recommendations made by relational
department.
DANGER!
Before disconnecting the power supply cables that connected with the power supply
module of this relay, make sure that the external miniature circuit breaker of the power
supply is switched off.
DANGER!
To decline the possibility of electrical shock, all current terminal should be shorted
before attempting to remove or replace any modules.
13.1.3 Dismantling
The rack of this relay may be removed from the system cubicle, after which the cubicles may also
be removed.
DANGER!
When the station is in operation, make sure that there is an adequate safety distance to
other operating parts or equipment, especially as dismantling is often performed by
unskilled personnel.
13.2 Disposal
In every country there are companies specialized in the proper disposal of electronic waste.
NOTICE!
Each module used in the device is fixed to several specific module type, as often
indicated with a label on the backside of the chassis. There are some chances that the
modules will be damaged if they are installed in the wrong chassis slot. When removing
and replacing modules, it is best to use the label in the chassis as an indicator, so as to
make sure each module is installed in the proper slot.
To Next Page
Loading...
Need help?
General