You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 5-63.
Check the box here, system can record motion detect event log.
5.5.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-64.
After analysis video, system can generate a video loss alarm when the detected moving signal reached
the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups, please refer
to chapter 5.5.3.1.1 motion detect for detailed information.
Figure 5-64
5.5.3.1.3 Tampering
The tampering interface is shown as in Figure 5-65.
After analysis video, system can generate a tampering alarm when the detected moving signal reached
the sensitivity you set here.
For detailed setups, please refer to chapter 5.5.3.1.1 motion detect for detailed information.
To Next Page
Loading...
