size.
The default max size is the full screen, you can select the blue line and then use mouse to adjust.
Click Clear to clear the zone you are drawing.
Click Ok to complete the rule setup.
Click to draw the zone. See Figure 5-74.
Figure 5-74
For detailed setups, please refer to chapter 5.5.3.1.1 motion detect for detailed information.
5.5.3.3.3 Abandoned Object Detect
It is to detect there is any abandoned object. Please use according to your actual situation.
Note:
The abandoned object detection function is valid once your network camera or your DVR supports
this function.
If you want to use the IVS function of the network camera, please make sure your connected
network camera supports this function.
From main menu->Setup->Event->IVS->Object, the interface is shown as below. See Figure 5-75.
Click to add the rule and select the rule type as Abandoned object detection, check the Abandoned
To Next Page
Loading...
Need help?
General