Application Guide | iC2-Micro Frequency Converters
P 6.6.3 Link Setups
Use this parameter to link or unlink setups. The link ensures synchronizing of the parameters that cannot be changed while the motor is
running. When setups are linked, it is possible to shift from 1 setup to another during operation. When selecting linked, the parameter
values of Edit Set-up are overwritten with the values of the other setup.
Default value: 20 Parameter type: Selection
Parameter
number:
12 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 Not linked
20 Linked
P 6.6.4 Set-up Copy
Use this parameter to copy parameters between set-ups.
Default value: 0 Parameter type: Selection
Parameter
number:
51 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 No copy
1 Copy from Set-up 1
2 Copy from Set-up 2
9 Copy from Factory Set-up
P 6.6.6 Reset Mode
Use this parameter to define whether the frequency converter waits for a manual reset, or resets itself automatically after tripping. In
manual reset mode, press the Stop/Reset button or use digital inputs to reset the frequency converter.
Default value: 0 Parameter type: Selection
Parameter
number:
1420 Unit: –
Data type: enum Access type: Read/Write
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 193
To Next Page
Loading...
Need help?
General
