Default value: 39 Parameter type: Selection
Parameter
number:
1301 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 FALSE Enters False in logic rule.
1 TRUE Enters True in logic rule.
2 Running See P 9.4.3.1 Function Relay [5] for description.
3 In range See P 9.4.3.1 Function Relay [7] for description.
4 On reference See P 9.4.3.1 Function Relay [8] for description.
7 Out of current range See P 9.4.3.1 Function Relay [12] for description.
8 Below I low See P 9.4.3.1 Function Relay [13] for description.
9 Above I high See P 9.4.3.1 Function Relay [14] for description.
16 Thermal warning See P 9.4.3.1 Function Relay [21] for description.
17 Mains out of range Mains voltage is outside the specified voltage range.
18 Reversing See P 9.4.3.1 Function Relay [25] for description.
19 Warning A warning is active.
20 Alarm (trip) A trip alarm is active.
21 Alarm (trip lock) A trip lock alarm is active.
22 Comparator 0 Use result of comparator 0 in logic rule.
23 Comparator 1 Use result of comparator 1 in logic rule.
24 Comparator 2 Use result of comparator 2 in logic rule.
25 Comparator 3 Use result of comparator 3 in logic rule.
26 Logic rule 0 Use result of logic rule 0 in logic rule.
27 Logic rule 1 Use result of logic rule 1 in logic rule.
28 Logic rule 2 Use result of logic rule 2 in logic rule.
29 Logic rule 3 Use result of logic rule 3 in logic rule.
33 Digital input T13 Use value of DI1 in logic rule.
34 Digital input T14 Use value of DI2 in logic rule.
35 Digital input T15 Use value of DIO in logic rule.
36 Digital input T17 Use value of DI3 in logic rule.
202 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Loading...
Need help?
General
