Danfoss iC2 - Page 5

Application Guide | iC2-Micro Frequency Converters
3.2.4.3 Menu Group Screen and Navigation 24
3.2.4.4 Restoring Default Settings 28
3.2.5 Control Panel 2.0 OP2 Buttons and Indicators 29
3.2.6 Control Panel 2.0 OP2 Basic Configurations 30
3.2.6.1 Overview 30
3.2.6.2 Understanding Readout Screens 30
3.2.6.3 Menu Screen and Navigation 31
3.2.6.4 Parameter Group Screens and Overall Navigation 32
3.2.6.5 Changing Selections in a Parameter 32
3.2.6.6 Changing Parameter Value 33
3.3 MyDrive® Insight 34
3.3.1 Overview of MyDrive® Insight 34
3.3.2 Getting Started with MyDrive® Insight 35
3.3.3 Accessing Parameters and Understanding Parameter Screens in MyDrive® Insight 36
3.3.4 Viewing and Changing Parameter Settings 39
3.3.5 PC Control to Operate the Drive using MyDrive® Insight 40
3.3.6 Backing Up the Drive 41
3.3.7 Restoring the Data to the Drive 43
4 Application Software Structure and Overview
4.1 Understanding Application Software Structure 45
4.2 Parameter Groups, Related Content, and Settings 45
5 Configuration Setup Examples
5.1 Introduction & Prerequisite 48
5.2 Basic Setup of a Drive 49
5.3 Setting up the Drive using Quick Access via Control Panel 50
5.4 Motor Configuration 50
5.4.1 Motor Configuration Overview 50
5.4.2 Asynchronous Motor Setup 50
5.4.3 PM Motor Setup in VVC+ 51
5.4.4 Speed Control Configuration with I/O Using Default 53
5.4.5 Automatic Motor Adaptation (AMA) 54
5.5 Application Selection 54
5.5.1 Application Selection Overview 54
5.5.2 Configuring Speed Control Mode 55
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 5