Danfoss iC2 - Page 65

Application Guide | iC2-Micro Frequency Converters
Table 20: Default Settings
Category Parameter index Parameter name Default setting Parameter number
Operation mode 5.4.2 Operation Mode [4] Torque Open Loop 100
DI 1 - T13 9.4.1.2 T13 Digital Input [8] Start 510
DI 2 - T14 9.4.1.3 T14 Digital Input [0] No operation 511
DI/O - T15 9.4.1.4 T15 Digital Input [1] Reset 512
DI 3 - T17 9.4.1.5 T17 Digital Input [14] Jog 513
DI 4 - T18 9.4.1.6 T18 Digital Input [0] No Operation 515
9.5.2.1 T33 Mode [1] Voltage Mode 619
9.5.2.2 T33 High Voltage 10V 611
9.5.2.3 T33 Low Voltage 0.07V 610
9.5.2.6 T33 High Ref./Feedb.
Value
The value should be
set manually accord-
ing to application re-
quirement.
615
AI1 - T33
9.5.2.7 T33 Low Ref./Feedb.
Value
0 614
9.5.3.1 T34 Mode [0] Current Mode 629
9.5.3.4 T34 High Current 20.00 mA 623
9.5.3.5 T34 Low Current 4.00 mA 622
9.5.3.6 T34 High Ref./Feedb.
Value
50. If [1] North Amer-
ica is selected for
P 1.2.1 Regional
Settings, the default
value is 60.
625
AI2 - T34
9.5.3.7 T34 Low Ref./Feedb.
Value
0 624
9.5.1.1 T31 Mode [0] 0-20 mA 690AO1 - T42
9.5.1.2 T31 Analog Output [100] Output Fre-
quency
691
Relay 9.4.3.1 Function Relay [9] Fault 540
5.5.3.5 Reference Function [0] Sum 304
5.5.3.7 Reference 1 Source [1] Analog Input 33 315
5.5.3.8 Reference 2 Source [0] No Function 316
External reference
5.5.3.9 Reference 3 Source [11] No Function 317
Speed Limit 5.10.3 Speed Limit Mode
Torque Ctrl.
[0] No Function 421
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 65