Parameter Setting
14-01 Switching Frequency
Higher operating switching frequency than specied by the individual lter is not recommended.
14-55 Output Filter
[0] No lter
14-56 Capacitance Output Filter
Not used
14-57 Inductance Output Filter
Not used
Table 6.27 Parameter Settings for dU/dt Filter Operation
6.2.10 Common Mode Filters
Enclosure size Order number Core dimension Weight
W [mm (in)] w [mm (in)] H [mm (in)] h [mm (in)] d [mm (in)] [kg (lb)]
A and B 130B3257 60 (2.36) 43 (1.69) 40 (1.58) 25 (0.98) 22.3 (0.88) 0.25 (0.55)
C1 130B7679 82.8 (3.26) 57.5 (2.26) 45.5 (1.79) 20.6 (0.81) 33 (1.3)
C2, C3, C4 130B3258 102 (4.02) 69 (2.72) 61 (2.4) 28 (1.1) 37 (1.46) 1.6 (3.53)
D 130B3259 189 (7.44) 143 (5.63) 126 (4.96) 80 (3.15) 37 (1.46) 2.45 (5.4)
Table 6.28 Common Mode Filters, Ordering Numbers
Figure 6.4 HF-CM Core
Type code and Selection Design Guide
MG20N622 Danfoss A/S © 09/2014 All rights reserved. 147
6 6