Danfoss VLT AQUA Drive FC 202

B
A
E
C
D
130BT324.10
A Top cover
B Brim
C Base part
D Base cover
E Screw(s)
Figure 3.32 Enclosure Size A3
Place the top cover as shown. If an A or B option is used,
the brim must be
tted to cover the top inlet. Place the
base part C at the bottom of the adjustable frequency
drive and use the clamps from the accessory bag to fasten
the cables correctly.
Holes for cable connectors:
•
Size A2: 2x M25 and 3xM32
•
Size A3: 3xM25 and 3xM32
Enclosure type
Height A
[mm (in)]
Width B
[mm (in)]
Depth C
1)
[mm (in)]
A2 372 (14.65) 90 (3.54) 205 (8.07)
A3 372 (14.65) 130 (5.12) 205 (8.07)
B3 475 (18.7) 165 (6.5) 249 (9.8)
B4 670 (26.38) 255 (10.04) 246 (9.69)
C3 755 (29.72) 329 (12.95) 337 (13.27)
C4 950 (37.4) 391 (15.39) 337 (13.27)
Table 3.20 Dimensions
1) If option A/B is used, the depth increases (see chapter 7.8 Power
Ratings, Weight and Dimensions for details)
E
F
D
C
B
A
130BT620.12
Figure 3.33 Enclosure Size B3
System Integration
VLT
®
AQUA Drive FC 202
76 Danfoss A/S © 09/2014 All rights reserved. MG20N622
33