Delfin LYRA - Page 37

Pag 37 / 154
Manuale Lyra 600 sx elettr eng
RESIDUAL RISK N. 3
Type of hazard
Mechanical type of hazards.
Cause
Moving elements.
Potential
consequences
Getting crushed or entangled between the machine’s mobile
parts.
Danger zone related
to cause of danger
Between the motorized pin of the infeed conveyor (1 fig.
2.7.1.1C) and the chain holder of the pusher rod (2 fig.
2.7.1.1C).
Phase of the
operating cycle
 Machine preparations.
 Machine use.
Task
Operator.
Dangerous event
Entering the danger zone with the machine running.
Risk frequency
 During machine preparations, when inserting the film, when
the machine is commanded to run in IMPULSE mode.
 During the packaging cycle risk frequency is unforeseeable
since the event is not usually part of normal machine usage.
Comment on
residual risk
The infeed conveyor’s fixed guards do not hinder entrance to the
danger zone.
 For IMPULSE mode runs, the manufacturer adopts additional
safety measures: low speed, press and hold commands,
indications in the instruction manual.
 During the packaging cycle the operator does not need to
enter the danger zones.
Risks for persons
Serious injuries to hands and fingers.
Fig. 2.7.1.1C Position of residual risk no. 3
1
2