Delfin LYRA - Page 41

Pag 41 / 154
Manuale Lyra 600 sx elettr eng
RESIDUAL RISK N. 7
Type of hazard
Heat hazard.
Cause
Very hot elements.
Potential
consequences
Getting burned and/or scalded on the machine’s hot parts.
Danger zone related
to cause of danger
On the clamps (1 fig. 2.7.1.1G) of the transversal seal/cut group.
Phase of the
operating cycle
 Machine preparations.
 Machine use.
 Machine cleaning.
 Machine maintenance.
Task
Operator.
Dangerous event
Entering the danger zone with the machine running and also
when it has just stopped.
Risk frequency
 During machine preparations, when inserting the film.
 During the packaging cycle, risk frequency is unforeseeable
since the event is not usually part of normal machine usage.
 When cleaning the transversal seal/cut group.
 During maintenance of the transversal seal/cut group.
Comment on
residual risk
The moveable guard of the longitudinal sealing group and that of
the outfeed conveyor do not prevent entrance to the danger
zone.
The temperature remains hazardous for about 30 minutes after
the machine has stopped.
Risks for persons
Serious injuries to hands or fingers.
Fig. 2.7.1.1G Position of residual risk no. 7
1