Develop ineo 3320 - Page 135

User's Guide
- 135 -
Use
To
Timeouts
Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Set the amount of time the printer waits before it goes to
Hibernate mode.
Notes:
• Disabled is the factory default setting for printers except
for European Union countries and Switzerland.
• “3 days” is the factory default setting for Class B printers
in all European Union countries and Switzerland.
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Set the printer to hibernate mode when there is an active
Ethernet connection.
Note: Do Not Hibernate is the factory default setting.
Timeouts
Screen Timeout
15–300 sec
Set the amount of time in seconds the printer waits before
returning the display to the Ready state.
Note: “30 sec” is the factory default setting.
Timeouts
Print Timeout
Disabled
1–255 sec
Set the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the remainder of the
print job.
Notes:
• “90 sec “is the factory default setting.
• When the timer expires, any partially printed page still in
the printer is printed, and then the scanner checks to see
if any new print jobs are waiting.
• Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print
jobs.