Develop ineo 3320 - Page 136

User's Guide
- 136 -
Use
To
Timeouts
Wait Timeout
Disabled
15–65535 sec
Set the amount of time in seconds the printer waits for
additional data before canceling a print job.
Notes:
• “40 sec” is the factory default setting.
• Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL
emulation print jobs.
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Automatically reboot the printer back into the normal operation.
Note: “Reboot when idle” is the factory default setting.
Error Recovery
Max Auto Reboots
1-20
Determine the number of automatic reboots the printer can
perform.
Note: 5 is the factory default setting.
Print Recovery
Auto Continue
Disabled
5–255
Let the printer automatically continue printing from certain
offline situations when these are not resolved within the
specified time period.
Note: Disabled is the factory default setting.
Print Recovery
Jam Recovery
On
Off
Auto
Specify whether the printer reprints jammed pages.
Notes:
• Auto is the factory default setting. The printer reprints
jammed pages unless the memory required to hold the
pages is needed for other printer tasks.
• On sets the printer to always reprint jammed pages.
• Off sets the printer to never reprint jammed pages.
Print Recovery
Jam Assist
On
Off
Set the printer to automatically check for jammed paper.
Note: On is the factory default setting.