Chapter 14: Solo and Monitor Busses 125
Activating 2-Track Input and Setting Level
To feed 2-Track input to the Monitor and Mains busses:
1 Go to the Options > Misc screen.
2 In the 2-Track section, click the Input Fed to Monitors and
Masters pop-up and select Analog 2-Track or Digital 2-Track.
To activate 2-Track input and set level:
1 Click the on-screen In button in the 2-Track section of the Op-
tions > Misc page.
2 Drag the on-screen Level knob in the 2-Track section of the
Options > Misc page.
Routing 2-Track to an Output Bus
To route the 2-Track inputs directly to an output bus:
1 Go to the Options > Misc tab.
2 Click the Route button in the 2-Track section on-screen. The
switch flashes to indicate Route to Selected mode.
3 Press the Select switch on each of the output channels
(Auxes, Groups, Matrixes, or Mains) where you want to route
2-Track signal. The Select switches flash to indicate 2-Track as-
signment.
4 Click Done in the Route to Selected dialog to confirm the as-
signment.
Routing to the 2-Track Outputs
You can route any output bus or Direct Output to the 2-Track
outputs.
To route any output bus to the 2-Track outputs:
1 Go to the Patchbay and click the Outputs tab.
2 To the left of the channel grid, click the tab for an Output
bus (Auxes, Groups, PQs, Matrixes, or Mains).
3 At the top of the channel grid, click the FOH tab.
4 Click in the channel grid to assign an Output bus (listed on
the left) to any of the following 2-Track output sources (listed
at the top right of the grid):
• AL (Analog Left)
• AR (Analog Right)
• DL (Digital Left)
• DR (Digital Right)
To route a Direct Output to the 2-Track outputs:
1 Go to the Patchbay and click the Directs tab.
2 To the left of the channel grid, click the tab for a channel
source (Channels, FX Returns, or Outputs).
3 At the top of the channel grid, click the FOH tab.
4 Click in the channel grid to assign a channel source (listed
on the left) to any of the following 2-Track output sources
(listed at the top right of the grid):
• AL (Analog Left)
• AR (Analog Right)
• DL (Digital Left)
• DR (Digital Right)
2-Track controls in the Options > Misc page
Signals are routed to output busses post-mute and post-
fader.
To Next Page
Loading...
