VENUE Profile Guide196
Snapshot Data Types and Parameters
Table 22. Snapshot data types and parameters included in each data type
Snapshot Data Type Included Parameters (for Each Scoped Channel Strip)
Fader Main volume level
Mute Mute state
EQ EQ type selection (analog/digital); EQ in-circuit state;
4 bands (2 bands on FX Returns) of gain, freq, Q, bell/shelf selection (digital only), band on/off
Dyn Compressor/Limiter in-circuit state; threshold, ratio, attack, release, knee, makeup gain
Expander/Gate in-circuit state; threshold, ratio, attack, release, hold time, range, side-chain input
Pan Channel pan or balance/width
(For details, see “Pan, Balance and Width Crossfade Reference” on page 195.)
Bus Group bus assignments, group bus mono/stereo-linked state (if mono groups) or dual-mono/true stereo state (if
stereo groups), L–R bus assignment and C/M bus assignments for input strips and groups
In Input routing for Input Channels and FX Returns
Out Main out assignments; direct out assignments, level, in-circuit state, & tap-off point (excluding VCAs)
H/W Hardware insert routing and in-circuit state (excluding VCAs)
VCA VCA membership
Pre Gain, pad, phase, phantom power, HPF corner frequency & in-circuit state
Name Name for each strip
MTX Mixer Input Sources, User Input Assignments, and pickoffs; Mixer Input level, Mixer Input on/off and Mixer Input
Link state
PQ Mixer Input Sources, User Input Assignment, and pickoffs; Mixer Input level, pan, and on/off state, Mixer input Link
state, LImiter threshold and LImiter in/out
Aux Mon On/off, pre/post selection, level, and pan/balance for each Aux bus classified as a Monitor Aux
Aux FX On/off, pre/post selection, level, and pan/balance for each Aux bus classified as an FX Aux
Dly Channel delay time & in-circuit
MIDI All MIDI messages that were added to the associated MIDI list for that snapshot.
Plug-Ins Rack slot settings, in-circuit state, and I/O routing for each plug-in added to plug-ins list for that snapshot
To Next Page
Loading...
