Chapter 2: Configuring and Connecting Profile 11
Using the Trackball Mount
The Trackball Mount can be removed and set up quickly.
To remove the Trackball Mount:
1 Holding the Trackball Mount in one hand, loosen the lock
nuts that secure it to the front of the console.
2 Drop the Trackball Mount off track to remove the entire as-
sembly from the console.
3 Replace the lock nuts onto the T-bolts and tighten them
down, to secure them in place.
To attach the assembled Trackball Mount to the console:
1 Loosen the two lock nuts securing the T-bolts in place, along
the extrusion at the front of the console.
2 Position the Trackball Mount so that its base slots line up
with the T-bolts, and slide the Trackball Mount into position.
3 Tighten the lock nuts to secure the mount into place.
Always disconnect USB and headphones from the front
panel before removing or attaching the Trackball Mount.
To Next Page
Loading...
Need help?
General
