VENUE Profile Guide58
5 Click Apply to reconfigure the system, or click Cancel to exit
without changing system settings.
Solo and Monitor Operations
These settings customize Solo and Monitor (cue) bus mode
and operation.
Type Solo mode choices include PFL (Pre-Fader Listen), Stereo
AFL (After-Fader Listen), and Solo-In-Place.
Level Trim Mirrors the functionality of the Solo/PFL level con-
trol on the control surface.
Monitoring Sets the level of the Headphone and Monitor out-
puts.
Delay Sets a delay for time-aligning headphones and near-field
monitors to the house system.
Auxes/Var Groups Follow AFL Puts the controls for an Aux
Send or Variable Group Send on the input channel encoders
whenever the AFL switch is pressed on that Aux or Var Group
bus.
AFL Follows Auxes/Var Groups Soloes the Aux (or Variable
Group) bus that is currently assigned to input encoders.
Auto Cancel Soloing a channel strip automatically takes any
currently soloed channels out of solo.
Input Priority Makes soloed inputs temporarily replace soloed
output busses on the AFL/PFL bus.
Mix to Monitors Mirrors the functionality of the Mix to Moni-
tors switch on the control surface.
Cue on Mains Fader Puts control of the Monitor bus level to
the Mains fader.
To configure Solo settings on-screen:
1 Go to the Options page and click the Busses tab.
2 Configure settings as needed:
To adjust Monitor Bus Delay, do one of the following:
Adjust the Delay encoder on-screen.
Click the Delay value shown on-screen, and manually enter
a new value.
To toggle Delay on or off:
Click to toggle the Delay In switch on-screen.
Matrixes
The Matrixes section lets you link and unlink Matrix to form
stereo Matrix busses.
Links When enabled, these options link corresponding mono
Matrix busses into stereo-linked pairs. Control changes then
affect both mono Matrix busses.
Panning/Center Divergence
The Panning section provides control over center channel di-
vergence when the Main Bus is set to L–C–R mode. See “Main
Bus Center Divergence Options” on page 83.
To set Center Divergence:
Enter a value or drag in the Center Divergence text box and
press Enter.
Stereo Group Panning Operation
The Stereo Group Panning Operation options provide differ-
ent levels of flexibility for how channels can be routed to
Groups.
To change Stereo Group Panning Operation:
1 Put the system in Config mode.
2 Click to select Simple or Expert mode.
For more information, see Chapter 10, “Aux Sends and
Variable Groups.”
Solo controls in the Options > Busses page
Delay settings are retained when toggled off or on.
For more information, see “Solo and Monitor Busses” on
page 117
For more information on these features see Chapter 11,
“Matrix and Personal Q Mixers.”
For more information on these options, see “Simple and Ex-
pert Operational Modes” on page 91.
To Next Page
Loading...
