Chapter 6: Options 61
Routing Osc, 2-Track and Talkback
Use the Patchbay to assign the Oscillator, 2-Track inputs, or
Talkback input to an Input or FX Return fader.
You can use the on-screen Route buttons to route oscillator,
2-track and talkback signals to outputs.
To route the Oscillator, 2-Track, or Talkback outputs on-screen:
1 In the Options > Misc page, click the Route button in either
the Oscillator, 2-Track, or Talkback sections.
2 Do either of the following:
• If you had already selected the desired output, click to
confirm the currently displayed Route To mode (in the
lower left corner of the screen).
• Go to the Outputs page and click to select an output (it
flashes briefly, otherwise the Outputs page remains fo-
cussed on the currently selected Output channel).
3 In the confirmation dialog that appears, click Route to con-
firm your assignment or click Cancel to cancel without chang-
ing the current routing.
For more information, see Chapter 12, “Patchbay.”
System Clock
Sets the date and time for the system.
Time of Day in Status Display
You can choose to show time of day in the lower right corner
of the screen in the Status display area. This optional display
can be configured for either 12 hour (AM/PM) or 24 hour for-
mat as follows:
To show time of day in the Status area:
1 Go to the Options > Misc page.
2 In the System Clock section, enable the Show Time in Status
Area option.
3 Select a format for the displayed time: 12 hour (AM/PM) or 24
hour.
Time of day is shown whenever the status of the plug-in racks
is OK; plug-in rack status messages (if any) temporarily replace
time of day display to alert you to plug-in rack status.
Channel Delay
Lets you set the display units on all applicable input and out-
put delay controls. This makes it possible to set the delay
based on any of the following:
• delay time (in milliseconds)
• distance to the source (in feet or meters)
• number of samples of delay
Tap Tempo
Lets you set the global system tempo, toggle system tempo
on/off, and choose to display tempo in BPM or ms.
On Turn on the global tempo sync by clicking the On switch
directly below the encoder so that it is lit (on).
Tempo Sets a system tempo value using the encoder or by typ-
ing a value directly into the Tempo field.
Units Lets you choose Beats Per Minute (BPM) or Milliseconds
as the units for displayed values.
Mouse
Pointer Speed and Mouse L/R Settings
You can customize the response speed for the trackball (or
mouse) and on-screen cursor, and reverse the left/right assign-
ment of the Trackball buttons, from the Options > Misc page.
To customize Pointer Speed:
1 Go to the Options > Misc page.
2 Do any of the following:
• To adjust cursor speed, click the Pointer Speed pop-up
menu and choose a higher value for faster response, or a
lower value for a slower response.
• To reverse the left/right assignment of the two Trackball
buttons, click to enable Switch Buttons.
Tap Tempo controls in the Options > Misc page
For more information, see “Tap Tempo for Plug-ins” on
page 207.
To Next Page
Loading...
