Troubleshooting Guide
SmartDate X40 BFSE Version 1.0 Feb 2011
154/286
Print Go Ignore (Continuous Printers Only)
• The SmartDate X40 may receive additional unwanted ‘Print Go’ signals from an
eye sensor during the print cycle, causing missed print warnings
• The Print Go Ignore setting can be used to set the distance following an accepted
‘Print Go’ signal the substrate must travel before further ‘Print Go’ signals are
accepted
• Where unwanted print signals are seen, set the Print Go Ignore to a little below
the length of the bag length. Remembering that if the bag length is changed the
Print Go Ignore must also be adjusted
Default - 2mm
To Next Page
Loading...
