Troubleshooting Guide
SmartDate X40 BFSE Version 1.0 Feb 2011
176/286
Missed Prints (Warning 2101 and Fault 1207)
Unless disabled, missed prints will be shown on the SmartDate X40 Controller as
‘Warning 2101’, and after a set number of consecutive missed prints, ‘Fault 1207’ will be
displayed.
Continuous mode
A missed print warning is displayed when the Print Go Ignore is not active and the
SmartDate X40 receives a print signal during the registration (The registration is a
distance setting in the SmartDate X40) or the registration is completed before the print
cycle is completed. (The Continuous print cycle is the time from when the ribbon starts
moving to when it stops moving.)
Print go
Print go ignore
Registration
Print Cycle
Valid
Ignored
(Print go ignore is active)
Missed print
(Print go ignore is NOT active)
(During registration period)
Valid
(Print cycle will complete before
registration is finished).
Missed print
(Classed as a valid print at first, but missed print logged when
registration completed as the print cycle is still active)
(Print go ignore is active)
Valid
registration is finished)
SmartDate X40 Continuous application
To Next Page
Loading...
