Troubleshooting Guide
SmartDate X40 BFSE Version 1.0 Feb 2011
194/286
Below is a typical event captured in the Event Log:
Event - Indicates the start of an event
DateTime – Is the time and date at which
the event occurred
Instigator - Is the device type - This should
always be SDX40
Event - Indicates the type of event
ID - Displays the event that triggered the
entry. Refer to Faults and Warnings
Value - States the status of the event. For
example, when a fault occurs the value is
‘Active’. When the fault is cleared, a new
event will be logged with a value of ‘Clear’
Printer Status – Indicates the current status
of the printer. This could be Ready,
Warning, Fault, Standby, Maintenance,
PackMLStateChange or Job Selection
Event - Indicates the end of the event
To Next Page
Loading...
