After Sales
SmartDate X40 BFSE Version 1.0 Feb 2011
201/286
To maintain consistent high quality performance from the SmartDate X40, these checks
should be performed at least once per month.
• Check the condition of the Peel Roller. Remove from the machine and look for debris
on the inside of the roller
• Check the condition of the Guide Rollers. Check the bearings are not loose and are
smooth running and the Guide Rollers are parallel to each other
• Check the condition of Timing Belt and Pulleys (Intermittent only)
• Check the condition of the Air Cylinders. Use the Controller to check the operation
of the Cylinders and make sure there are no air leaks
General Cleaning and Care
To ensure that the SmartDate X40 operates correctly, the entire unit should be regularly
cleaned.
Printer:
Particular attention should be given to the inside of the Printer body, especially if food
products are able to fall into the unit.
• Turn off the power to the Controller
• Turn off and isolate the air supply to the Printer body
• Remove the Cassette and clean inside the Printer body. Since there are
electronic components inside this casing, DO NOT use water to clean the
unit. Isopropanol cleaning wipes can be used for this purpose
• To clean debris from the inside of the Printer body, Markem.Imaje
recommend the use of a soft bristle brush
To Next Page
Loading...
