Pre-Installation
SmartDate X40 BFSE Version 1.0 Feb 2011
49/286
• Followed by two prints
of between 85 and
175 mm/s
• Pack rate calculations
must allow for the
slowest and fastest
speeds
Remember, the machine must also be allowed to recover after printing before another
‘Print Go’ signal can be accepted.
The recovery time required is the sum of:
• Head Up time
• Ribbon Rewind time
If not enough recovery time is available the
printer will not respond to a ‘Print Go’ signal
and will generate a missed print warning.
To Next Page
Loading...
