Pre-Installation
SmartDate X40 BFSE Version 1.0 Feb 2011
55/286
Intermittent 'L’ Bracket
Limited compatibility with SmartDate X40i (see Page Erreur ! Signet non défini.)
To establish compatibility CHECK:
• Cable and air pipe will route to opposite side of Printer
• Registration can be adjusted by -15mm
• Printer has +20mm clearance on opposite side to Bracket Mount
Continuous 'L’ Bracket
Limited compatibility with SmartDate X40c (see Page Erreur ! Signet non défini.)
To establish compatibility CHECK:
• Encoder cable can be re-routed to the Printer
• ‘L’ Bracket has alternative Print Roller position
• Cable and air pipe will route to opposite side of Printer
• Printer has +20mm clearance on opposite side to Bracket Mount
To Next Page
Loading...
