Dover markem-imaje SmartDate X40 - Page 95

Installation
SmartDate X40 BFSE Version 1.0 Feb 2011
95/286
5 - External I/O Connector
Pin Description
1
+24 VDC - I/O
2
PRINT GO Input(PNP sensor or +24V Switched) Controller PCB Link –
X11 Position A -PNP
3
0 V - I/O
4
User Configurable Digital Input 1(PNP sensor or +24V Switched) Controller
PCB Link –
X12 Position A -PNP
5
Reserved
6
Reserved
7
Fault Output (Contacts Open for Fault)
8
Fault Output (Contacts Open for Fault)
9
Warning Output (Contacts Close on Warning)
10
Warning Output (Contacts Close on Warning)
11
User Configurable Digital Output 1# (24V PNP)
12
0 V - I/O
13
User Configurable Digital Output 2# (24V PNP)
14
Reserved
15
Reserved
6 - Printer Power / Control Connector
A single cable connects the Controller to the Printer body
7 - Mains Connector, fuse and power switch
The power input and fuse carrier. This cable can be up to 10 meters in length. The
cable must be inserted into the Controller and
the Printer body and firmly secured
before switching on the unit