Dräger Julian - Connecting the Measured Gas Recirculation System

1 Press the overflow protection float into the rising pipe
until it clicks into place. The float must move freely
without falling out.
2 Uniformly button the silicone sleeve onto the cover.
● Connect the bottle cap to the secretion collecting
bottles.
● Place the secretion collecting bottle in the inner
sleeve and the rinsing bottle in the outer sleeve.
3 Fit the vacuum hose to the port on the Julian and to
the thin port on the cap.
4 Fit the suction hose to the thick port on the cap.
5 Fit the secretion inspection window in the suction
hose.
Connecting the measured gas recirculation system
6 Fit the short hose to the port of the measured gas
outlet.
7 Fit the long hose to the port of the recirculation
system.
109
Care
Assembling
4
5
3
3
4
5
1
2
6
7
"Only for internal use by Draeger. Not applicable as Instructions for Use!"