Dräger Julian - Interface; Setting Default Alarm Limits; Setting Default Alarm Limits for Anaesthetic Agents

Configuring in Standby Mode
Setting default values
86
Interface
Choice between configuration of COM2 or COM3.
Baud rate
Transmission speed (variable, see Instructions for Use of
the equipment to be connected).
Parity
This display is invariable for MEDIBUS and is shown only
for information.
Data bits
This display is invariable for MEDIBUS and is shown only
for information.
Stop bits
This display is invariable for MEDIBUS and is shown only
for information.
Setting default alarm limits
● Turn the rotary knob to select the line »alarm limits«
and press to confirm.
The »alarm limits« menu appears in the left-hand field.
Display (example):
● Select and confirm the required alarm limit with the
rotary knob.
The default alarm limit is highlighted against a white
background.
● Set and confirm the value with the rotary knob. The
value is then displayed in normal mode.
The cursor bar jumps to the next default alarm limit.
● Set the next default alarm limit as described above.
Setting default alarm limits for anaesthetic agents
● Turn the rotary knob to select the line
»anaesth. agent« and press to confirm.
The corresponding menu is displayed.
Standby / Configuration
anesth. agent
calibration
0 1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
adult child
default settings
Menu for configuration of default alarm limits.
pulse tone
alarm sound
scale
parameters
record
interfaces
alarm limits
curves
basic configurations
IPPV default settings
PCV default settings
fresh gas delivery
--
95
40
30
120
50
3.0
--
--
20
40
8
SpO
2
etCO
2
MV
Fi O
2
PAW
anaesth. agent
"Only for internal use by Draeger. Not applicable as Instructions for Use!"