Applying the Durasensor DS-100 A
Reusable sensor for short-term monitoring of relatively
quiet patients weighing over 40 kg.
The sensor is preferably positioned on the index finger,
although other fingers can also be used. The little finger
should be used if the patient is particularly large or
obese.
● Open the clip slightly and slide the sensor onto the
finger. The tip of the finger must touch the end and
the soft padding should rest on the nail and tip of the
finger. The lead should be on top of the finger.
● Ensure that the finger is not compressed or hurt by
the clip.
● Change the application site after not more than
4 hours in order to avoid a build-up of blood pressure
(blocked circulation).
Follow the specific Instructions for Use when using other
Nellcor sensors!
79
Monitoring
SpO2 Measurement
"Only for internal use by Draeger. Not applicable as Instructions for Use!"
To Next Page
Loading...
