Fitting emergency ventilation bag
Example: Dräger Resutator 2000
● Insert the adapter in the bag so that the rubber flange
is uniformly located in the groove of the adapter.
● Press the retaining ring together completely with the
large eyelet pointing towards the bag and clamp it
over the bead on the bag.
1 Place the diaphragm in the bottom part of the valve
with the lip facing downwards.
Screw the upper part of the valve onto the bottom
part.
2 Plug the patient valve into the bag adapter.
Connecting the anaesthetic gas scavenging system
AGS
3 Connect the transfer hose to the excess gas
connector and to the port of the scavenging system.
4 Connect the suction hose to the port of the
scavenging system.
5 Connect the anaesthetic waste gas connector to the
suction hose.
6 Ensure that the second port on the scavenging
system is sealed with the sealing screw.
● Note the Instructions for Use of the anaesthetic gas
scavenging system AGS.
6
3
3
5
4
3
111
Care
Assembling
1
2
"Only for internal use by Draeger. Not applicable as Instructions for Use!"
To Next Page
Loading...
