Using non-rebreathing systems
Example: Bain system
● Prepare the Bain system in accordance with the
separate Instructions for Use.
For the specified monitoring of O2, CO2 and anaesthetic
agents:
1 Screw the sample line to the Luer lock connection of
the mask manifold pipe and to the water trap on the
back of the workstation.
For mask pipes without sample line connector:
● Place a T-piece with filter between the mask pipe and
fresh gas connection port.
or:
● where applicable, use the Luer lock connection of a
filter.
2 Connect the fresh gas hose of the Bain system to the
fresh gas outlet.
3 Connect the anaesthetic gas scavenging system AGS
to the Bain system.
● Note the Instructions for Use of the Bain system.
Display (example):
In MAN/SPONT ventilation mode:
● Press the softkey »Fresh gas internal/external«,
select »Fresh gas external« and confirm by pressing
the rotary knob.
50
Operation
Using non-rebreathing systems
3
2
1
MAN/SPONT
Pleth
40
0
CO
2
40 36
0.8 0.6
58 56
38
98 67
5.2 8
4.0030
Start volumeter: Confirm !
O
2
SpO
2
N
2
O
Hal.
Fi
Fet
etCO
2
MV
freq
alarm
limits
CO
2
-al.
on/off
alarm
info
list
curves
config.
Freshgas O
2
+ N
2
O
fresh gas
O
2
%
L/min
VT
0.35
0
Volumeter
--s
--
0510
0.5
1
_
CO
2
Ve
internal
external
"Only for internal use by Draeger. Not applicable as Instructions for Use!"
To Next Page
Loading...
