Dräger Julian - Setting the Measuring Parameters

84
Configuring in Standby Mode
Setting default values
Setting the measuring parameters
● Select the line »parameters« with the rotary knob and
press to confirm.
The »parameters« menu appears in the left-hand field.
Display (example):
Switch SpO2 measurement (optional) on/off:
● Select the line »SpO2 measurement« with the rotary
knob and press to confirm.
● Select »on« or »off« with the rotary knob and press
to confirm.
Select the sample rate for gas measurement:
● Select the line »sample rate« with the rotary knob
and press to confirm.
● Select »60« or »200 mL/min« with the rotary knob
and press to confirm.
For paediatric use:
● Select a sample rate of 200 mL/min in order to obtain
more accurate values on account of the high frequen-
cies and time constant of the measuring system.
● Recirculate the measured gas, see page 109.
If the measured gas is not recirculated:
● Increase the minute volume accordingly in order to
maintain the volume balance.
For adult use:
● Select a sample rate of 60 or 200 mL/min.
Recommendation: select 200 mL/min and recirculate
the measured gas, see page 109.
Set CO2 unit:
● Select the line »CO2 unit« with the rotary knob and
press to confirm. The last value selected is highlighted
by a grey background.
● Select the required unit of measure by turning the
rotary knob and press to confirm.
Standby / Configuration
anesth. agent
calibration
0 1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
adult child
SpO
2
-measure.
sample rate
CO
2
unit
on off
60 200 mL/min
mmHg kPa vol%
default settings
Menu for configuration of measurement parameters.
pulse tone
alarm sound
scale
parameters
record
interfaces
alarm limits
curves
basic configurations
IPPV default settings
PCV default settings
fresh gas delivery
"Only for internal use by Draeger. Not applicable as Instructions for Use!"