Dräger Julian - Screen Display Options

Monitoring
Selecting the standard screen
The standard screen is automatically displayed on the
screen whenever a ventilation mode is selected
(MAN/SPONT or IPPV or PCV). This page can always
be selected during operation:
1 Press the Q key
or
2 Press the
S
key several times.
Display (example):
The most important parameters are grouped together on
the right-hand side of the screen.
Three curves are displayed on the left-hand side
(to select other curves, see page 66).
Measured values shown in grey
Calibration is performed automatically by Julian. The
measured values are shown in grey until sufficient data
are available and until the sensors have reached their
operating temperature.
In this way, Julian indicates that the accuracy of these
data is still reduced in comparison with the "Technical
data".
For maximum accuracy the sensors can be calibrated
manually – see page 75.
When measuring CO2, anaesthetic agent and N2O, their
numerical values are shown in grey during the warm-up
phase whenever the workstation is switched on.
The display CAL appears instead of the numerical value
during automatic calibration of the O2 sensor (every
24 hours).
The flow sensor is automatically calibrated as soon as a
CO2 signal is detected by the gas measuring system.
Julian takes account of the relevant gas mixture when
calculating the volumetric concentrations.
Monitoring
Selecting the standard screen
56
Julian
2
1
Pleth
IPPV
alarm
limits
auto set
limits
alarm
info
list
curves
CO
2
40
0
PAW
0
20
config.
O
2
SpO
2
N
2
O
Hal.
40 36
0.8 0.6
58 56
Fi
Fet
etCO
2
38
98 67
6.0 10
MV
freq
600
V
T
mL
10
1:2
10 0
PEEP
mbar
Freq.
1/min
T
I
:T
E
T
IP
:T
I
%
25
Pmax
mbar
Freshgas O
2
+N
2
O
4.00
O
2
%
L/min
30
_
CO
2
Ve
"Only for internal use by Draeger. Not applicable as Instructions for Use!"