Fitting waste gas connector
1 Push waste gas connector into the aperture all the
way to the stop, angle downwards.
2 Fit hose to connector.
Sample gas scavenging
If the sample gas is not to be recirculated:
● Use hose 11 90 520, connector M 33 151 and
sealing cap (optional).
2 Connect the hose to the port of the sample gas
outlet port.
3 Fit the connector with sleeve to the free end of the
hose.
Insert the connector in the coupling of the anaesthetic
gas scavenging system until it clicks into place.
4 Fit the cap to seal the port.
1
2
Care
Assembling
110
2
3
4
"Only for internal use by Draeger. Not applicable as Instructions for Use!"
To Next Page
Loading...
