Assembling
Installing the breathing system
1 Place the bottom section on a flat surface.
2 Fit the valve plate on the bottom section.
3 Insert both valve discs.
4 Tightly fit the cover.
5 Tighten all five sealing screws a quarter-turn.
6 Hang the breathing system into the slot-in unit.
Inserting the flow sensor
7 Insert the flow sensor with the electric connection in
the slot.
8 Push in the expiration port with the nose of the port in
the slot.
● Tighten the knurled nut by hand.
1
2
3
3
5
4
5
55
5
5
Care
Assembling
106
8
7
6
"Only for internal use by Draeger. Not applicable as Instructions for Use!"
To Next Page
Loading...
