Dräger Julian - Starting the Volumeter; Using the Volumeter Function

Using the volumeter function
To observe and assess ventilation in manual and
pressure controlled ventilation modes and during
spontaneous breathing.
➀ Upper bar:
Current tidal volume VT, preceded by the numerical
value.
➁ Lower bar:
Volumeter (minute volume measurement), preceded
by the numerical value.
The scale of the bar display depends on the default
setting, see "Configuring in operation, selecting the
scale" on page 69
and "Configuring in standby mode, selecting the scale"
on page 83.
Starting the volumeter
● Press the rotary knob.
The values are deleted and volumeter restarted if the
rotary knob is pressed again before
60 seconds have elapsed.
The elapsed time in seconds is displayed above the bar
with the summed volume on the left. The individual
breaths are separated by segments in the bar. The
volumeter stops automatically with an acoustic signal
after 60 seconds.
The measured values are displayed for 4 minutes and
then erased.
67
Monitoring
Using the volumeter function
Setting Tidal volume VT
in L
Minute
volume MV
in L/min
Scale
for children
0.2 2
Scale
for adults
1.0 10
MAN/SPONT
Pleth
40
0
CO
2
40 36
0.8 0.6
58 56
38
98 67
5.2 8
4.0030
VT
0.35
0
Volumeter started. To re-start:
Confirm !
0.5
1
O
2
SpO
2
N
2
O
Hal.
Fi
Fet
etCO
2
MV
freq
alarm
limits
CO
2
-al.
on / off
alarm
info
list
curves
config.
Freshgas O
2
+ N
2
O
O
2
%
L/min
Volumeter 46 s
4.1
05
10
fresh gas
_
CO
2
Ve
internal
external
➀
➁
VT
0.35
0
0.5
1
Volumeter 46 s
4.1
05
10
"Only for internal use by Draeger. Not applicable as Instructions for Use!"