Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016 99
To set the fullness:
1. Select the type of fullness.
Th
e type of fullness selected is displayed in an activated
control field within the symbol.
2. If a higher or lower degree of
fullness is required, use the
arrow keys to display more buttons.
3. Input the fullness using the buttons 0 to 16.
Mode
PROG
RAMMING
Other program parameters
A tap on the Other program parameters button will bring up an
overview of all available parameters.
Fig. 64: Other program parameters
Parameters Meaning
Backtack at Start Bartack at seam beginning
Value range: 1 (= on) or 0 (= off)
To Next Page
Loading...
