Programming
122 Service Instructions 869-M PREMIUM - 00.0 - 07/2018
19.7.12 Setting the QONDAC (QONDAC) parameter
Machines can be interlinked to allow for networked operation.
Various settings can be made for the networking of the machines.
The possibilities are explained in more detail in the table.
For detailed information on how to network machines, refer to the
documentation of the QONDAC.
19.7.13 Setting the Fast menu keys (FastMenuKeys) parameters
The fast menu keys can only be used in manual mode. They are shown in
the bottom section of the display on the control panel. None of the param-
eters that may have been selected for the info screen are displayed.
Program Selective restriction of access to the existing program and its
parameters
R/W – Read/Write
Off – Area is hidden
R/O – Read Only
Programming It is not possible to create new programs; it is not
possible to edit existing programs
(Value range: On/Off)
St.Len.Corr Restriction of access to the correction factor for
the stitch length
(Value range R/W, OFF, R/O)
Tens.Corr Restriction of access to the correction factor for
the needle thread tension
(Value range R/W, OFF, R/O)
Menu item Setting options
On/Off QONDAC active/inactive
Customer ID Editor that lets you set the customer ID
Ethernet Config Adjustment of the Ethernet configuration
Symbol Meaning
Start bartack
(off/single/double)
End bartack
(off/single/double)
Menu item Setting option
To Next Page
Loading...
Need help?
General
