Programming
Service Instructions 869-M PREMIUM - 00.0 - 07/2018 137
11. Press the OK button to confirm the selection.
12. Press the
► button; the selection Destination, Select All,
Deselect All appears.
13. Select the Destination option with the
▲/▼ buttons.
14. Press the OK button to confirm the selection.
15. Select the desired folder with the
▲/▼ buttons or press the ► button
and create a new folder with the Create Folder option.
16. Press the OK button to confirm the selection.
17. Give the folder a name using the numeric buttons.
18. Press the OK button to confirm the name.
19. Press the
► button and select the Copy option.
20. Press the OK button to confirm the selection.
The data transfer begins and a message appears, stating that the
USB key must not be removed:
Fig. 106: USB key warning
The message disappears after the data transfer.
19.11.4 Saving the Error list (Error Log) parameter
The error list can be saved to a USB key.
To save the error list to a USB key:
1. Plug the USB key into the control.
2. Select the Error Log parameter and press the OK button to confirm.
A warning appears - the USB key will be erased completely before
the error list is compiled!
3. Press the OK button to acknowledge the error message.
The error list is written to the USB key.
19.12Performing a software update
When a new software version is available, this can be downloaded from
www.duerkopp-adler.com and loaded into the control via a USB key.
All settings on the machine are retained.
To load software via a USB key:
1. Switch off the machine at the main switch.
2. Plug the USB key into the socket (1) on the control (2).
Bitte warten!
To Next Page
Loading...
Need help?
General
