Programming
Service Instructions 869-M PREMIUM - 00.0 - 07/2018 97
19.6 Machine config. submenu
Settings on the machine that apply to all programs can be made here.
The parameters are explained in more detail in the subchapters.
The menu is divided into the following submenus:
Parameter Explanation Reference
Thread Trim Thread cutter p. 98
Thread clamp Thread clamp p. 99
Speed Speed p. 101
Stop Positions Stop positions p. 101
Foot Sewing foot p. 102
Thr.Tens. Needle thread tension p. 102
Stroke Sewing foot stroke p. 103
Stitch length Stitch length p. 104
Bobbin Bobbin p. 104
Holding Force Motor holding force p. 104
Pedal Pedal p. 106
Needle cooling Needle cooling p. 106
Center Guide Seam middle guide p. 107
Puller Puller p. 107
EdgeGuide Edge guide p. 109
Mat.Thickness Material thickness detection p. 109
Speed Corr Correcting effects of high speed p. 110
Light barrier Light barrier p. 110
Mode Seg.Size Segment length p. 111
Threading Threading mode p. 111
Operation lock Operation lock p. 111
To Next Page
Loading...
Need help?
General
