Programming
Service Instructions 869-M PREMIUM - 00.0 - 07/2018 123
19.7.14 Setting the Contrast (Contrast) parameter
Set the contrast of the OP3000 to the user's needs here.
To set the parameter:
1. Select the Contrast parameter.
2. Press the OK button to confirm the selection.
3. Enter the desired value (010 – 255).
4. Press the OK button to confirm the value.
19.7.15 Setting the Brightness (Brightness) parameter
Set the brightness of the OP3000 to the user's needs here.
To set the parameter:
1. Select the Brightness parameter.
2. Press the OK button to confirm the selection.
3. Enter the desired value (000 – 255).
4. Press the OK button to confirm the value.
Thread cutter
(active/inactive)
Needle position
(bottom/top)
Sewing foot position
(bottom/top)
Symbol Meaning
To Next Page
Loading...
