Programming
132 Service Instructions 869-M PREMIUM - 00.0 - 07/2018
The reset is carried out immediately after selecting a subitem with the
arrow buttons and then pressing OK. There is no further query, and
neither is there a message stating that the reset was performed.
To reset the data:
1. Select the Reset parameter.
2. Press the OK button to confirm the selection.
3. Select the desired option – see the table – with the
▲/▼ buttons.
4. Press the OK button to confirm the selection.
The reset is carried out without any further query and without a
confirmation message.
Options for resetting the data
19.11Data Transfer submenu
Use this submenu to transfer data between the machine – or more precisely
the control – and a USB key. Various options are available for the data
transfer, which are explained in the subchapters.
The menu is divided into the following submenus:
Important
It is permitted only to use USB keys bought from Dürkopp Adler.
Menu item Setting options
Reset data All parameters are reset to the factory settings; this does not apply
to the programs and the calibration values.
Reset programs All created programs are erased.
Reset Calibr. All calibration values are reset to the factory settings.
Reset all All parameters, programs, and calibration values are reset to the
factory settings.
Parameter Explanation Reference
All data All data p. 133
Only Data Only data p. 134
Programs Programs p. 135
Error Log Error list p. 137
To Next Page
Loading...
Need help?
General
