Dynon Avionics SkyView - Dynon Autopilot Servo Models; Compass Calibration Requirement; Additional Resources

Autopilot Servo Installation, Configuration, and Calibration
10-2 SkyView System Installation Guide - Revision K
If you no longer have this capability, contact Dynon Technical Support. Your servos
can be returned to Dynon for a firmware update.
Dynon Autopilot Servo Models
Dynon currently offers the following servo models:
Model Number
Torque
Attachment
SV32
36 inch-pounds
Standard Arm
SV32L
Long Arm
SV32C
Capstan
SV42
55 inch-pounds
Standard Arm
SV42L*
Long Arm
SV42C
Capstan
SV52
72 inch-pounds
Standard Arm
SV52L*
Long Arm
SV52C
Capstan
Table 39–Dynon Servos
* SV42L/SV52L servos are special order items–contact Dynon Avionics for details.
Compass Calibration Requirement
The SkyView autopilot requires an accurate magnetic heading to operate efficiently and
comfortably in heading mode and the radio-based VOR/NAV mode. Therefore it is critical that
the ADAHRS be installed correctly, calibrated, and operating well in all attitudes.
Additional Resources
Dynon’s Internet sites provide frequently updated information on installation and operation
issues:
wiki.dynonavionics.com – Dynon’s Documentation Wiki provides enhanced, extended,
frequently updated online documentation contributed by Dynon employees and customers.
forum.dynonavionics.com – Dynon’s Online Customer Forum is a resource for Dynon Avionics
customers to discuss installation and operation issues relating to Dynon Avionics products. The