Dynon Avionics SkyView - Post Installation Checks

Vertical Power VP-X Integration and Configuration
13-4 SkyView System Installation Guide - Revision K
 SYSTEM AMPS: Sets the current levels for the entire electrical system at which caution
and warning indications are provided visually on the VP-X page.
 ALTERNATOR AMPS: Sets the current levels for the alternator at which caution and
warning indications are provided visually on the VP-X page.
 BATTERY AMPS: Sets the discharge rate at which caution and warning indications are
provided visually on the VP-X page.
 SKYVIEW AMPS SHUNT LOCATION: Depending on your electrical layout, your SkyView
shunt may be in one of a few places in your electrical system.
 AILERON TRIM POSITION: Set to SkyView EMS if your trim position signal input is routed
to your SV-EMS-220 module, or to VP-X if it is connected to your VP-X system instead. If
set to VP-X, the engine page trim widget will be automatically sourced from the VP-X
data.
 ELEVATOR TRIM POSITION: Set to SkyView EMS if your trim position signal input is
routed to your SV-EMS-220 module, or to VP-X if it is connected to your VP-X system
instead. If set to VP-X, the engine page trim widget will be automatically sourced from
the VP-X data.
 FLAP POSITION: Set to SkyView EMS if your flaps position signal input is routed to your
SV-EMS-220 module, or to VP-X if it is connected to your VP-X system instead. If set to
VP-X, the engine page flaps widget will be automatically sourced from the VP-X data.
Post Installation Checks
 Follow all installation, configuration, and test procedures as instructed by the Vertical
Power documentation.
 Ensure that your VP-X system is powered on and functioning normally.
 On a SkyView display that is displaying the Engine Page (enabled by toggling MENU >
SCREEN > ENGN PG), press to MENU > ENGINE > VP-X. The Engine page will
automatically re-arrange itself to show VP-X information as seen in the image below. If
the VP-X page is covered by a red “X”, the VP-X is either not communicating with
SkyView, is not properly configured, or is inoperative.