SkyView System Installation Guide - Revision K 13-1
13. Vertical Power VP-X Integration and Configuration
Dynon SkyView can interface with the Vertical Power VP-X System to provide robust monitoring
and control of your electrical system via your SkyView system. In order to use this feature, a
Vertical Power VP-X system is required, along with a software license for the VP-X features
within SkyView.
License Information
The VP-X software features are enabled on Dynon SkyView by purchasing a VP-X license code
from Dynon Avionics and entering it into your SkyView system. Only one VP-X license is needed
in a SkyView system, no matter how many displays are attached. That license is applied to only
one display, but that display stores the license information for the entire system. In normal use,
license information is shared with all displays connected via SkyView Network to allow the VP-X
features to be operated on any display in the system.
Checking License Status
To check whether a SkyView system is licensed to use the VP-X software features, go to SETUP
MENU > LOCAL DISPLAY SETUP > LICENSE, and look at the status of the Vertical Power line.
Possible license statuses include:
LICENSED (THIS DISPLAY): The SkyView system is licensed to enable the use of the
Vertical Power software features. This display stores the license information and also
allows other displays in the aircraft to access the Vertical Power features.
LICENSED - CONNECTED DISPLAY ONLINE: The SkyView system is licensed to use the
Vertical Power software features. This display is currently connected to a licensed
display.
LICENSED DISPLAY OFFLINE - XX HOURS REMAIN The SkyView system is licensed to use
the Vertical Power software features. However, the display that actually stores the
license information is not currently connected. When this happens, the Vertical Power
software features will continue to be accessible for 30 flight hours beyond when it last
saw the licensed display in the aircraft. Once the licensed display is seen again, this
timer is cleared.
NO LICENSE: No display in the SkyView system is licensed to use the Vertical Power
features.
Purchasing and Installing a VP-X License
A license can be purchased and applied to your system in one of two ways:
3. Call Dynon Avionics directly at 425-402-0433 with your SkyView display model (SV-D100
or SV-D700) and serial number (as displayed on the case sticker, or in SETUP MENU >
LOCAL DISPLAY SETUP > DISPLAY HARDWARE INFORMATION). A VP-X License Code can
be purchased for the entire aircraft you wish to enable the VP-X software features on.
This six character License Code is then entered in SETUP MENU > LOCAL DISPLAY SETUP
To Next Page
Loading...
